|Magnet type||Solenoid pullmagnet|
|Outer ØD [mm]||32|
|Thread||M10 & M3 (see drawing below)|
|Initial force [N]||3.5|
|Hold force [N]||11|
ED's is a percentage measure of the connection time. If the magnet are supposed to work shorter (lower ED), you can increase voltage and get more power.
Lower voltage gives lower force. But be wary, during high power / voltage, the coil will heat up fast and if you are not careful, it will melt / burn up.
Stated holding power applies in ideal conditions without safety factor.
|Strength [Newton]||Initial force||Hold force||Initial force||Hold force||Initial force||Hold force||Initial force||Hold force||Initial force||Hold force|
You have added Pullmagnet S=5mm D=32mm 3,5N ED-100% at 24V to your quotation request.