Push & Pullmagnet S=5mm D=32mm 3,5N ED-100% at 24V
Artno: 05032/DE
| Magnet properties | |
|---|---|
| Magnet type | Solenoid pullmagnet |
| Weight [grams] | 280 |
| Outer ØD [mm] | 32 |
| Length [mm] | 95 |
| Solenoid | |
| Stroke [mm] | 5 |
| Thread | M10 & M3 (see drawing below) |
| Initial force [N] | 3.5 |
| Hold force [N] | 11 |
| ED [%] | 100 |
| Voltage [V] | 24DC |
| Power [W] | 6 |
| IP-code | IP40 |
| Current [A] | 0.25 |
Description
Double acting solenoid
This solenoid is a so-called double acting magnet. This means that it can work both as a pull magnet and a pressure magnet. If the right cable pair (as shown on the drawing below)
is connected to 24V, the magnet operates as a pull-magnet (threaded rod is pulled inward), and if the left cable pair is connected, it works as a pushmagnet (threaded rod is pushed outwards).
ED's is a percentage measure of the connection time. If the magnet are supposed to work shorter (lower ED), you can increase voltage and get more power.
Lower voltage gives lower force. But be wary, during high power / voltage, the coil will heat up fast and if you are not careful, it will melt / burn up.
Stated holding power applies in ideal conditions without safety factor.
| ED% | 100 | 40 | 25 | 15 | 5 | |||||
| Power [Watt] | 6 | 12 | 16.8 | 24 | 54 | |||||
| Strength [Newton] | Initial force | Hold force | Initial force | Hold force | Initial force | Hold force | Initial force | Hold force | Initial force | Hold force |
| 3.5 | 11 | 6 | 20 | 8.4 | 27 | 10 | 30 | 15 | 38 | |
